Repara tus cosas Comunidad Tienda

Sustitución de la tapa trasera de Microsoft Surface

Aviso: Estás editando una guía de requisitos previos. Cualquier cambio que realices afectará a todas las 4 guías que incluyen este paso.

Paso anterior

Traduciendo paso 6

Volver a la Guía
Inglés
Español
Paso 6
Microsoft Surface Rear Cover Replacement: paso 0, imagen 1 de 3 Microsoft Surface Rear Cover Replacement: paso 0, imagen 2 de 3 Microsoft Surface Rear Cover Replacement: paso 0, imagen 3 de 3

  • Rotate the device 180 degrees so that the bottom of the device is facing you.

  • A ribbon connects the battery on the rear cover, to the motherboard. Slowly lift the bottom of the rear cover up until you can see the ribbon.

  • Use a spudger to push the ribbon away from the motherboard and parallel to the motherboard in order to remove the ribbon.

  • Separate the rear cover by lifting it up away from the main system.

  • When reassembling the rear cover to the motherboard, reinserting the ribbon cable with a spudger may prove difficult. In this case, gently use your hands to slide the cable end into the slot until they click into place.

Gira el aparato 180 grados de modo que la parte inferior del aparato quede orientada hacia ti.

Una cinta conecta la batería de la tapa trasera con la placa base. Levanta lentamente la parte inferior de la cubierta trasera hasta que puedas ver la cinta.

Utiliza un spudger para empujar la cinta lejos de la placa base y en paralelo a la placa base con el fin de eliminar la cinta.

Separa la cubierta posterior levantándola para separarla del sistema principal.

Al volver a montar la cubierta posterior en la placa base, puede resultar difícil volver a insertar el cable plano con un spudger. En este caso, utiliza suavemente las manos para deslizar el extremo del cable en la ranura hasta que encajen en su lugar.

[* black] Rotate the device 180 degrees so that the bottom of the device is facing you.
[* red] A ribbon connects the battery on the rear cover, to the motherboard. Slowly lift the bottom of the rear cover up until you can see the ribbon.
-[* light_blue] Use a spudger to push the ribbon away from the motherboard and parallel to the motherboard in order to remove the ribbon.
+[* orange] Use a spudger to push the ribbon away from the motherboard and parallel to the motherboard in order to remove the ribbon.
[* black] Separate the rear cover by lifting it up away from the main system.
[* icon_note] When reassembling the rear cover to the motherboard, reinserting the ribbon cable with a spudger may prove difficult. In this case, gently use your hands to slide the cable end into the slot until they click into place.

Tus contribuciones son autorizadas bajo la licencia de código abierto de Creative Commons.

OSZAR »